Switching LED Screen​​​​​

Publisher: Supplier of LED Display Time: 2022-02-09 18:00 Views: 673


Switch LED screen precautions

dym.jpg

1. Switch sequence:

When the screen is turned on: first power on, then turn on the screen.

When the screen is turned off: turn off the screen first, then shut down

(Turn off the computer first without turning off the display screen, which will cause bright spots on the screen body, and the LEDs will burn the lamps, which will cause serious consequences.)


2. The time interval of switching the screen should be more than 5 minutes.


3. After the computer enters the engineering control software, the screen can be powered on.


4. Avoid opening the screen in a completely white screen state, because the inrush current of the system is the largest at this time.


5. Avoid opening the screen in an out-of-control state, because the inrush current of the system is the largest at this time.

A computer does not enter the control software and other programs;

B computer is not powered;

C control section power is not turned on.


6. When the ambient temperature is too high or the heat dissipation conditions are not good, the led lighting should be careful not to open the screen for a long time.


7. When a part of the electronic display screen appears very bright, you should pay attention to closing the screen in time. In this state, it is not suitable to open the screen for a long time.


8. The power switch of the display screen often trips, and the screen body should be checked or the power switch should be replaced in time.


9. Regularly check the firmness of the connection. If there is any looseness, pay attention to timely adjustment, re-reinforce or update the hanger.


10. According to the environment of the large-screen display screen and the control part, avoid insect bites, and place anti-rat medicine if necessary.